Fujitsu PRIMERGY TX100 S1 서비스 보충 설명서 - 페이지 35
{카테고리_이름} Fujitsu PRIMERGY TX100 S1에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX100 S1 46 페이지. For tx100 s1
Fujitsu PRIMERGY TX100 S1에 대해서도 마찬가지입니다: 사양 (13 페이지), 옵션 매뉴얼 (46 페이지), 기술 매뉴얼 (32 페이지)
페이지 인쇄
Replacement routines
4.7
Replacing the processor
V
CAUTION!
Processors are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a
processor has been removed from its protective sleeve or from its socket,
place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.
Ê Open the server, and remove the air duct as described in
ration" on page
Figure 20: Removing heat sink
Ê Loosen the four screws in a crossover pattern.
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
TX100 S1
17.
Service Supplement
Replacing the processor
section "Prepa-
35