Fujitsu PRIMERGY TX1330 M4 고객 서비스 정보 게시판 - 페이지 3

{카테고리_이름} Fujitsu PRIMERGY TX1330 M4에 대한 고객 서비스 정보 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX1330 M4 3 페이지. Customer information bulletin

PRIMERGY

warning message will be displayed indicating the jumper is placed in a password

clear position.

5. Enter UEFI (BIOS) setup, go to 'Save and Exit' tab and choose 'Save Changes

and Reset'

6. Disconnect the power cables

7. Place the jumper in the neutral position (see Fig. 1/1a)

8. Close the housing

9. Connect the power cables. The system will not start before the iRMC is ready

10. Power On the system as soon as the iRMC is ready (when the power LED stops

blinking)

 Do not be concerned if the system switches off in POST and starts again

11. Enter UEFI (BIOS) setup, check and correct the necessary settings (especially

SATA operation mode if you are using the onboard SATA RAID functionality)

12. After the desired BIOS settings are set make sure to 'Save Changes and Reset'

Revision History

REVISION

DATE

0000

14 April 2020

CUSTOMER INFORMATION BULLETIN

CHANGE SUMMARY

Initial Release