Fujitsu PRIMERGY TX150 S6 서비스 보충 설명서 - 페이지 23

{카테고리_이름} Fujitsu PRIMERGY TX150 S6에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX150 S6 45 페이지.
Fujitsu PRIMERGY TX150 S6에 대해서도 마찬가지입니다: 사용 시 참고 사항 (8 페이지)

페이지 인쇄

Replacement routines

Ê Fasten the Power backplane with the knurled screw in the PS cage.

Ê Plug the power cables on the system board and the drives (see the cabling

plans in the Options Guide).

Ê Reinstall the hot-plug power supply unit(s).

Ê Close the server and connect all power plugs (for a detailed description see

the Options Guide).

4.5

Replacing the 3.5" SAS/SATA backplane

The 3.5" SAS/SATA backplane is mounted on the hard disk cage. It is not

necessary to remove the hard disk cage before replacing the SAS/SATA

backplane.

Ê Open the server as described in the

Ê Remove all the hot-plug hard disk drives (for a description see the Operating

Manual).

CAUTION!

Check if all hard disk drives are uniquely identified so that you can

reinsert them into their original bays.

Figure 6: Disconnecting cables - 3.5" SAS/SATA backplane

Ê Take the I

C cable out of the green cable clamp and remove the cable clamp

(1).

Ê Pull out the connectors of the power cable (2), the I

cable (4) from the 3.5" SAS/SATA backplane.

TX150 S6

Replacing the 3.5" SAS/SATA backplane

section "Preparation" on page

Service Supplement

C cable (3) and the SAS

17.