Fujitsu PRIMERGY TX150 S6 서비스 보충 설명서 - 페이지 30

{카테고리_이름} Fujitsu PRIMERGY TX150 S6에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX150 S6 45 페이지.
Fujitsu PRIMERGY TX150 S6에 대해서도 마찬가지입니다: 사용 시 참고 사항 (8 페이지)

페이지 인쇄
Fujitsu PRIMERGY TX150 S6 서비스 보충 설명서

Replacing the processor

Ê Pull the first removed intrusion switch out of the cable clamp.
V
CAUTION!
Note the cable routing.
Ê Remove the intrusion switch cable from the connector on the system board
(see also the Technical Manual of the system board).
Ê Plug the new intrusion switch cable to the connector on the system board.
Ê Route the intrusion switch cable.
Ê Position the intrusion switch with the three wires on the front cover and
fasten it with two screws.
Ê Insert the intrusion switch with the two wires in its holder and fasten the
switch with two screws.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
4.9
Replacing the processor
V
CAUTION!
Processors are modules which can react extremely sensitively to electro-
static discharges and which must therefore always be handled with care.
After a processor has been removed from its protective sleeve or from its
socket, place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.
Ê Open the server as described in the
30
section "Preparation" on page
Service Supplement
Replacement routines
17.
TX150 S6