Fujitsu PRIMERGY TX150 S8 시스템 구성자 및 주문 정보 매뉴얼 - 페이지 9
{카테고리_이름} Fujitsu PRIMERGY TX150 S8에 대한 시스템 구성자 및 주문 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX150 S8 24 페이지. Mono-socket intel xeon processor server
Fujitsu PRIMERGY TX150 S8에 대해서도 마찬가지입니다: 데이터시트 (10 페이지)
페이지 인쇄
D
III
Section
Memory
- There are 6 memory slots for max.
96GB using RDIMM (6x 16GB 2R)
24GB using UDIMM (6x 4GB)
- The memory area is divided into 3 channels with 2 slots per channel
- Slot 1 of each channel belongs to memory bank 1, the slot 2 belongs to memory bank 2,
Registered and unbuffered memory modules can be selected
No mix of registered and unbuffered modules allowed.
Memory can be operated at 1.5V or 1.35V, even if the modules are of low voltage type.
Memory operating voltage can be set within BIOS (1.5V is default setting for max. speed).
In a 2 DIMMs per channel configuration, following frequencies are supported:
- 1.5V - 1600MHz max (depending on CPU, special memory modules)
SDDC (Chipkill) is supported for registered x4 organized memory modules only
1.) In the "Independent Channel Mode" is following configuration possible
Channels can be populated in any order in Independent Channel Mode. All 3
channels may be populated in any order and have no matching requirements. All
channels must run at the same interface frequency but individual channels may run at
different DIMM timings (RAS latency, CAS latency, and so forth)
No mix of registered and unbuffered modules allowed.
2.) "Rank Sparing Mode" configuration
- Within a memory channel, one rank is a spare of the other ranks.
The Spare Rank is held in reserve and is not available as system memory
For the effective memory capacity, please refer to the spreadsheet below.
The BIOS is set to the rank sparing setting.
Minimum configuration is: 2x 1R, 2x 2R or 1x4R DDR3 module per channel
This mode is not supported by x8 organized memory modules
3.) "Performance Mode" configuration
- In this configuration, the memory module population ex factory is spread across all channels.
The BIOS is set to the max. performance for memory.
Minimum configuration is: 3x identical modules
4.) In the "Mirrored Channel Mode" is following configuration possible
- Each memory bank can optionally be equipped with 2x registered memory modules
In each memory bank channel B and C has to be
equipped with identical modules for mirrored channel mode.
In channel C is always the mirrored memory of channel B
Minimum configuration is: 2x identical modules
This mode is not supported by x8 organized memory modules
D1
Fujitsu PRIMERGY Server
System configurator and order-information guide
PRIMERGY TX150 S8
Status 2016-02-29
9 of 24