Fujitsu Primergy TX300 S4 설치

{카테고리_이름} Fujitsu Primergy TX300 S4에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Primergy TX300 S4 3 페이지. Pre-attached rack conversion kit
Fujitsu Primergy TX300 S4에 대해서도 마찬가지입니다: 시스템 구성 및 주문 정보 매뉴얼 (17 페이지), 수동 시작 (8 페이지), 사용 시 참고 사항 (4 페이지)

페이지 인쇄

��

Check all of the Rackmount kit items

The rackmount kit for installation into a rack is supplied with the server. First check that none of the

following items are missing. If any items are missing or defective, contact an office listed in the "Contact

Information" of the "Start Guide".

Slide rail : 1 pair

□

��

Installing the server into the rack

The procedure for installation to the server into the rack is explained here.

The left or the right in this manual is defined when the rack is viewed from the front.

- Be sure to secure the rack with stabilizers to prevent the device from tipping over. For details on installing the rack, refer to the

manual provided with the rack.

- The weight of the server exceeds 35kg. When you carry the server, make sure more than three people do it to secure the

right and left sides and the bottom of the body.

Open both the front and rear doors of

the rack.

Check where to attach the slide rail and

rack nuts.

As seen in the figure below, the base surface of the

server must be positioned at where the intervals

between the rack bracket holes are narrow.

��

TX300 S4

��

M3 Flathead screw : 4

□

Washer : 2

□

Attach M5 rack nuts.

Use 4U per device. Insert the latches of the rack nuts

from the inside of the rack bracket into 2nd and 11th

holes (counting from the position where the server is

installed) to attach the rack nuts.

��

B7FH-5341-01EN Z0-00

M5 Flathead screw : 2

□

M5 Rack nut : 4

□

��