Fujitsu SPARC Enterprise M3000 제품 노트 - 페이지 26
{카테고리_이름} Fujitsu SPARC Enterprise M3000에 대한 제품 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC Enterprise M3000 38 페이지.
Fujitsu SPARC Enterprise M3000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (8 페이지), 안전 및 규정 준수 매뉴얼 (34 페이지), 제품 노트 (42 페이지)
페이지 인쇄
XCP Issues Fixed in Releases Earlier Than XCP
1091
TABLE 6
XCP Issues Fixed in Releases Earlier Than XCP
TABLE 6
ID
Description
RTIF1-
When remote power control mode of
070824-001
interlocking mechanism for power supply to
domain, is enabled, after the motherboard unit
is replaced, the interlocking for power supply
by RCI cannot work.
RTIF1-
After set the Daylight Saving Time by using
080725-004
the XSCF shell, XSCF Web does not show the
correct time in the Logs menu.
RTIF1-
The error log "XSCF FMEM write error"
081006-001
recorded and the firmware update might fail.
RTIF1-
In the setemailreport(8) command, when
081006-002
you specified over 255 characters in the SMTP
address, an error results.
RTIF1-
During the domain operation, after the XSCF
081006-003
reset due to the XSCF unit failure, the
hardware status shows Deconfigure in the
status of CPU and memory.
RTIF1-
During the firmware update, there might be
081006-004
the following output message and a XSCF
panic might occur.
kernel BUG in jffs2_do_read_inode
at fs/jffs2/readinode.c:XXX!
RTIF1-
The network configuration on the XSCF Web
081006-005
does not support the function equivalent to the
setnetwork -r comand. And when you
specified localhost or localdomain to the host
name or the domain name, the error message
"SessionID has expired" appears.
RTIF1-
The panic log on the XSCF Web might not be
081006-006
displayed from the top of the message.
RTIF1-
The password(8) command indicates that the
081006-007
[user] operand is optional but will fail if a
[user] operand is not included when other
options are specified.
18
SPARC Enterprise M3000 Server Product Notes for XCP Version 1091 • April 2010
lists XCP issues that have been fixed in releases earlier than XCP 1091.
1091
Workaround
After the motherboard unit is replaced,
configures the RCI again and sets the remote
power control mode.
No workaround is available.
Use the showlogs(8) command of the XSCF
shell.
Power off (AC OFF) the system, and power on
(AC ON) again. Then, re-execute the firmware
update.
Do not specify over 255 characters in the SMTP
address.
eplace the motherboard unit only. When no
failure found on the memory, you do not need
to replace the memory.
Reset XSCF and use the flashupdate(8)
command to retry the firmware update.
Use the setnetwork -r command on the
XSCF shell.
When the output is insufficient, execute the
showlogs panic command on the XSCF shell.
No workaround is available.
Specify the user operand to execute the
password(8) command when you specify
other options.