Fujitsu SPARC Enterprise M3000 제품 노트 - 페이지 26

{카테고리_이름} Fujitsu SPARC Enterprise M3000에 대한 제품 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC Enterprise M3000 42 페이지.
Fujitsu SPARC Enterprise M3000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (8 페이지), 제품 노트 (38 페이지), 안전 및 규정 준수 매뉴얼 (34 페이지)

페이지 인쇄

Configuring XSCF for Active Directory Support

The commands setad(8) and showad(8) let you set and view the Active Directory

configuration from the command line.

By default, Active Directory support is disabled. To enable Active Directory support,

use the following command:

XSCF> setad enable

To disable Active Directory support, use the following command:

XSCF> setad disable

To show if Active Directory support is enabled or disabled, enter:

XSCF> showad

Use the setad(8) command with its various parameters to configure Active

Directory. For example, you can use it to set up one primary and five alternate

Active Directory servers, assign group names and privileges, configure a particular

user domain, control logging of diagnostic messages, and more. User domain can be

configured explicitly through the setad userdomain command on XSCF, or

entered at login prompt using the form, user@domain.

See the setad(8) and showad(8) man pages, and the note about these commands in

TABLE 11

Configuring XSCF for LDAP/SSL Support

The commands setldapssl(8) and showldapssl(8) let you set and view

LDAP/SSL configuration from the command line. These commands do for

LDAP/SSL what the setad(8) and showad(8) commands do for Active Directory,

and support many of the same parameters.

For more information, see the setldapssl(8) and showldapssl(8) man pages.

Notes on User Account Name and UID

If the Service Processor is configured to use Lightweight Directory Access Protocol

(LDAP), Active Directory, or LDAP/SSL for user account data, the user name and

UID (if specified) must not already be in use locally or in LDAP, Active Directory, or

LDAP/SSL.

SPARC Enterprise M3000 Server Product Notes for XCP Version 1093 • July 2010