Fujitsu SPARC Enterprise M8000 제품 노트 - 페이지 30

{카테고리_이름} Fujitsu SPARC Enterprise M8000에 대한 제품 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC Enterprise M8000 44 페이지. For xcp version 1041
Fujitsu SPARC Enterprise M8000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (4 페이지), 기능 설명서 (30 페이지), 보충 설명서 (36 페이지)

페이지 인쇄

XCP Issues and Workarounds (Continued)

TABLE 5

Description

RTIF1-

Time can't be synchronized with the NTP

070904-005

server.

RTIF1-

While executing the domain power-on,

070904-006

domain reset or DR, in case the XSCF reboot

occurred, the process may be aborted in some

or all of the XSB.

RTIF1-

If an invalid SMTP server is configured, a

070912-001

subsequent attempt to disable email service

(using the setemailreport CLI) may block for

up to 30 minutes.

SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1041 • October 2007

Workaround

Check the stratum value of the NTP server.

The stratum value of XSCF is "5." The NTP

server which the XSCF refers to must be a

server on which the stratum value is smaller

than 5. When you changed the NTP server to

refer to, reboot the XSCF.

When the stratum value has been set correctly

and the time can't be synchronized, use the

showntp(8) command to check the jitter value

to be displayed.

If this value is large, please reboot the XSCF.

Execute the domain reset one more time, or

power off the domain and then power on

again.

Wait for the CLI to complete. The rest of the

system will function normally during this

time.

• The CLI can also be aborted by ^C. Note that

the operation (disabling emailreport) is

completed, even if ^C is used.

• showemailreport can be used to confirm

that the service has been disabled.