Fujitsu SPARC Enterprise T2000 제품 노트 - 페이지 21

{카테고리_이름} Fujitsu SPARC Enterprise T2000에 대한 제품 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC Enterprise T2000 28 페이지.
Fujitsu SPARC Enterprise T2000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (2 페이지), 시작하기 매뉴얼 (12 페이지), 제품 노트 (30 페이지)

페이지 인쇄

Specific Issues for the SPARC Enterprise T2000 Server (6 of 6)

TABLE 1

CR ID

Description

6781815 After the ALOM reset or the power cable removal

and insertion, when the server powered on, Solaris

OS startup at the ok prompt of OBP (OpenBoot

PROM) using the boot command may fail.

Error output example:

{0} ok boot

ERROR: All device paths in boot-device

have failed. (*)

{0} ok

It cannot refer to the device paths that configured in

the OBP environmental variable boot-device and

fails to start Solaris OS.

6886045 Start of the FMA (Fault Management Architecture)

service may not complete. And due to the derived

event, the Solaris OS shutdown may not terminate.

For details, see

Complete (CR 6886045)" on page

6875992 During system operation, an event may repeatedly

occur that the server internal fan shows the failed

state (log: "SYS_FAN at FT0/FMx has FAILED.")

and then gets back to normal (log: "SYS_FAN at

FT0/FM1 is OK.") one second later. For details, see

"Repeatedly Occurs an Event of Internal Fan Status

Error Which Gets Back to Normal One Second Later

(CR 6875992)" on page

Start of FMA Service May Not Complete (CR 6886045)

This issue has been fixed in System Firmware 6.7.8 or later.

Start of the FMA (Fault Management Architecture) service may not complete. And

due to the derived event, the Solaris OS shutdown may not terminate.

Event 1)

Start of the Fault Management Architecture (FMA) service may not complete. When

you executed the svcs(1M) command and the FMA service is offline, and if there

exist two fmd processes as the ps(1M) command execution result, this event has

been occurred.

"Start of FMA Service May Not

13.

14.

Important Information About the SPARC Enterprise T2000 Server

Workaround

Note - Fixed in System Firmware 6.7.5 or later.

After the ALOM reset or the power cable removal

and insertion, when you power on the server,

check the OBP environmental variable. Especially,

in case the OBP environmental variable use-

nvramrc? has been set to true, it is necessary in

advance of starting the OS to see the ok prompt

and check that use-nvramrc? has been set to

true and then execute the boot command.

Confirmation example:

{0} ok printenv use-nvramrc?

use-nvramrc? = true

{0} ok

Note - Fixed in System Firmware 6.7.8 or later.

None.

Note - Fixed in System Firmware 6.7.8 or later.

Ignore the output message.