Fujitsu SPARC ENTERPRISE T5240 시작하기 매뉴얼

{카테고리_이름} Fujitsu SPARC ENTERPRISE T5240에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC ENTERPRISE T5240 8 페이지. Fujitsu sparc enterprise t5140 server getting started guide
Fujitsu SPARC ENTERPRISE T5240에 대해서도 마찬가지입니다: 개요 매뉴얼 (28 페이지)

페이지 인쇄

SPARC

Enterprise T5140 Server Getting Started Guide

Enterprise T5140 サーバはじめにお読みください

SPARC

This guide describes the minimum steps you must perform to get your server to power on and boot for the first time

using the preinstalled Solaris™ Operating System (Solaris OS).

SPARC Enterprise T5140 Server

FIGURE 1

Quick Setup Instructions

For quick installation and configuration, follow these steps. For more detailed information, refer to the complete online

product documentation set at:

Understand the following information before you set up the server for the first time:

Choose the best instructions for your situation – These quick setup instructions work for any networking

■

environment, and require the use of a terminal device for connectivity to a serial port. If you have a networking

environment running DHCP, you can configure your system using the Ethernet management port. To take advantage

of DHCP setup method, refer to the online installation guide instead of these instructions.

Set aside sufficient time – Installation times vary, but if you are performing these setup instructions for the first time,

■

plan to spend about 45 to 75 minutes to complete all of these instructions. Additional time might be required for

installing optional hardware and rackmounting kits.

Gather your configuration information – During the configuration, you are prompted for time zone and networking

■

parameters that are specific to your environment. For a list of information you need, see

Obtain a terminal device – You configure this rackmountable server through the service processor (SP) using the

■

built-in serial and network management ports, and not through a graphical interface and keyboard. For more

information about the terminal device, see

Do not apply power at this time – This system includes a service processor (SP) that is used to configure and boot the

■

main host server. To properly configure the host server and view SP messages, do not apply AC power to the server

until the SP and host networking connections are made, as described in this guide.

http://www.fujitsu.com/sparcenterprise/manual/

Step

Shipping Contents

Quantity

Item

Server

RJ-45 Ethernet cable

RJ-45 to DB-25 adapter (crossover)

RJ-45 to DB-9 adapter (crossover)

Wrist strap

Power cords (packaged separately)

Rackmounting kit with cable

management assembly

Step