Fujitsu FI 6140 - Document Scanner 시작하기 매뉴얼 - 페이지 12
{카테고리_이름} Fujitsu FI 6140 - Document Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI 6140 - Document Scanner 20 페이지. Image scanner
Fujitsu FI 6140 - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (6 페이지), 사양 (2 페이지), 사용 설명서 (10 페이지), 시작하기 (23 페이지), 청소 지침 (2 페이지)
페이지 인쇄
3.
When the scanner is automatically detected, [Found
New Hardware Wizard] or [Add/Remove Hardware
Wizard] dialog box appears. Click the [Cancel]
button to close the Wizard dialog box.
4.
Insert the "Setup CD-ROM" into the CD drive.
⇒
<SETUP DISK START UP SCREEN> appears.
ATTENTION
This screen may not appear if the "AutoPlay" setting is set to
off. In this case, find "Install.exe" in the CD-ROM using
"Explore" or "My Computer" and execute it.
5.
Click [INSTALL PRODUCTS], and then click [ISIS
Driver].
6.
Error Recovery Guide Installation dialog box
appears.
Error Recovery Guide is an application with which you
can view on-screen information for troubleshooting
errors that may occur in the scanner. This guide helps
solve problems, so select [Yes] to install it. You may
also choose to install it later.
ATTENTION
After you select [Yes] for installing Error Recovery Guide,
the [Choose Setup Language] dialog box appears. Select a
language and follow the on-screen instructions. The Error
Recovery Guide dialog box is automatically displayed
when the installation is complete. Wait until the installation
of the ISIS driver starts.
7.
Select a language for the installation on the
[Choose Setup Language] dialog box, and then
click the [Next] button.
7
8.
Install the driver, following the on-screen
instructions.
9.
When you see the [InstallShield Wiizard Complete]
dialog box, click the [Finish] button.
Your computer will restart and detect the scanner. Do not
remove the Setup CD-ROM from the CD drive until your
computer completely starts up again.
ATTENTION
Depending on the operating system you are using, you
may need to do the following.
Windows 2000:
If you see the [Digital Signature not Found] dialog box, click
[Yes].
Windows Vista:
If you see the [Found New Hardware] dialog box, select
[Locate and install driver software], and then in the [User
Account Control] dialog box, click the [Continue] button, if it
is displayed.
The installation of FUJITSU ISIS is complete.
Next, install ScandAll PRO (
ATTENTION
To make sure that FUJITSU ISIS is successfully installed,
perform a scan with a ISIS-compliant application such as
ScandAll PRO. For information about how to scan with
ScandAll PRO, refer to section "2.4 Checking Scanner
Driver Operation" on page 9.
ScandAll PRO
■ Installing ScandAll PRO
ScandAll PRO is software for scanning images, which is in
compliance with both TWAN/ISIS standards. Using
FUJITSU TWAIN 32 or FUJITSU ISIS together with
ScandAll PRO allows you to create document images.
ATTENTION
Be sure to log on as a user with "Administrator" privileges.
1.
Insert the Setup CD-ROM into the CD drive.
⇒
<SETUP DISK START UP SCREEN> appears.
2.
Click [INSTALL PRODUCTS], and then click
[ScandAll PRO].
page 7).