Brother MFC-5840CN 빠른 설정 매뉴얼 - 페이지 6

{카테고리_이름} Brother MFC-5840CN에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-5840CN 37 페이지. Brother internet fax user's guide
Brother MFC-5840CN에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 빠른 설정 매뉴얼 (39 페이지), 서비스 매뉴얼 (8 페이지)

페이지 인쇄
Brother MFC-5840CN 빠른 설정 매뉴얼
Step 1
Removing the Protective
1
Parts
1
Remove the protective tape and paper.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.

Loading Paper

2
For Tray#2, see To load paper in the paper
tray#2 (MFC-5840CN only) on page 5.
You can load up to 100 sheets of 80 g/m
paper in Tray#1 and 250 sheets of 80 g/m
paper in Tray#2.
For more details, see "About paper" in
Chapter 1 of the User's Guide.
To load paper or other media
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
2
Press and slide the paper side guide to fit
the paper width.
Paper Side Guide
4

Setting Up the Machine

3
Pull out the paper support and unfold the
paper support flap.
Paper Support Flap
Use the paper support flap for Letter, Legal
and A4 size paper.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
2
5
2
Gently insert the paper into the paper tray
print side down and the leading edge (top of
the paper) in first.
Check that the paper is flat in the tray and
below the maximum paper mark.
■ Make sure the paper side guides touch
the sides of the paper.
■ Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
Paper Support
Maximum Paper Mark