Fujitsu FI-4120C2 - Document Scanner 시작하기 - 페이지 11
{카테고리_이름} Fujitsu FI-4120C2 - Document Scanner에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-4120C2 - Document Scanner 28 페이지. Image scanner
Fujitsu FI-4120C2 - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 브로셔 및 사양 (2 페이지)
페이지 인쇄
1.3 Operator Panel
The operator panel is located on the right side of the
scanner. This panel comprises of a Function Number
display, four buttons and a LED.
Name
Function Number
display
Button
Function
Send to
Scan
Power
button
LED
-
About the settings on the launcher, refer to
*)
FUJITSU TWAIN32 scanner driver help and the
"fi-4120C2 Operator's Guide" in the Setup CD-
ROM.
Function No.
display
Function
Send to
Scan
Power button
LED
Function
Indicates the function
Number and error status.
Changes the Function acti-
vated by the Send to button
(*).
Launches the linked appli-
cation software (*).
Turns the scanner ON and
OFF.
Lights when the scanner is
turned ON.
fi-4120C2 Image Scanner Getting Started
■ Indications on the Function
Number display
■ 8
Blinks only one time upon turning on the scan-
ner.
■ P
Indicates that the scanner has been turned ON
and is being initialized.
■ 0
Indicates that initialization will soon end.
■ 1
Indicates that initialization has ended success-
fully.
The scanner is now in "Ready Status".
■ U
Indicates that a temporary error occurred when
documents were being scanned. A number
appearing in alternation following the U (i.e.,
1 or 2, etc.) refers to the type of error.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
■ E
Indicates that a device (hardware) alarm has
occurred during scanning of documents.
"E" and the alarm Number (2 to 9, c and d)
will appear alternately.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and on
again. If the alarm continues after turning the
power on again, contact your service engineer.
2