Fujitsu fi-4220C2 시작하기 - 페이지 4

{카테고리_이름} Fujitsu fi-4220C2에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-4220C2 30 페이지. Flatbed scanner
Fujitsu fi-4220C2에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 브로셔 및 사양 (2 페이지), 설치 절차 (3 페이지), 청소 지침 (2 페이지)

Fujitsu fi-4220C2 시작하기
INTRODUCTION
Thank you for purchasing the fi-4220C2 Duplex Color
Scanner product.
This document describes how to handle fi-4220C2
Duplex Color and basic operation methods. Before you
start using fi-4220C2 Duplex Color be sure to thor-
oughly read this manual to ensure correct use.
The "Operator's Guide" is stored on the Setup Disk.
The guide provides useful and detailed information on
Operations when you would like to using advanced fea-
tures, daily maintenance of the scanner, replacement of
consumables.Please also read the Operator's Guide for
your reference.

■ Regulatory Information

FCC Declaration
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
located.
Consult your dealer or an experienced radio/TV
technician.
FCC warning: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
ii
The use of a shielded interface cable
ATTENTION
is required to comply with the Class B
limits of Part 15 of FCC rules.
The length of the AC cable must be 2
meters (6.6 feet) or less.

Canadian DOC Regulations

This digital apparatus does not exceed the Class B
limit for radio noise emissions from digital
apparatus set out in the Radio interference
Regulations of the Canadian Department of
Communications.
This Class B digital apparatus complies with
Canadian ICES-003.
Le pésent appareil numérique n'ément pas de
bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe
B prescridtes dans le Réglesment sur le brouillage
radioélectrique dicté par le ministere des
Communications du Canada.
Cet appareil numérique de la classe B est
conformme à la norme NMB-003 du Canada.
Bescheimigung des Herstellers /
Importeurs
Hiermit wird bescheinigt, daß der/die/das
fi-4220C2
In Übereinsstimmung mit den Bestimmungen
der EN45014(CE) funkentstört ist.
Laut Maschinenlärminformationsverordnung 3.
GS GV, 18.01.1991:Der höchste
Schalldruckpegel beträgt 70 dB (A) oder
weniger gemäß ISO/7779.
International E
NERGY
E
As an
NERGY
Partner, PFU LIMITED has
determined that this product
E
meets the
NERGY
guidelines for energy efficiency.
The International
Equipment Program is an international program
that promotes energy saving through the
penetration of energy efficient computers and
®
S
Program
TAR
S
®
TAR
S
®
TAR
E
S
®
NERGY
TAR
Office