Fujitsu fi-4530C 시작하기 - 페이지 14

{카테고리_이름} Fujitsu fi-4530C에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-4530C 27 페이지. Image scanner
Fujitsu fi-4530C에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 브로셔 및 사양 (2 페이지), 설치 절차 (3 페이지), 소모품 교체 및 청소 지침 (14 페이지), 청소 지침 매뉴얼 (13 페이지), 청소 지침 (2 페이지), 사용 설명서 (10 페이지), 설치 절차 (5 페이지)

페이지 인쇄

Depending on the OS, the following oper-

ATTENTION

ations may be necessary.

For Windows 98:

When a request for inserting the CD-

ROM of Windows 98 appears, insert it

into the CD drive and click the [OK] but-

ton.

For Windows 2000:

When [Digital Signature not Found]

appears, click [Yes].

For Windows XP:

1. When [Found New Hardware Wizard]

appears, confirm that the Setup

CD-ROM is set in the CD drive, then

click the [Next] button.

2. When any alarm is displayed on [Hard-

ware Installation] window, click the

[Continue Anyway] button.

3. Click the [Finish] button.

Now the installation of the scanner driver is completed.

For confirming if the installation was suc-

ATTENTION

cessful, perform a scanning operation by

using an application that complies with

the TWAIN regulations such as ScandAll

21.

■ Installing ScandAll 21

"Scandall 21" is image capturing software that complies

with the TWAIN standard. With the FUJITSU TWAIN

32 scanner driver, you can capture images by using a

FUJITSU image scanner fi-series product.

When using Windows NT 4.0, Windows

ATTENTION

2000 or Windows XP, log on as a user

with "Administrator" privileges (privi-

leges of the administrator of your PC).

1. Insert the Setup CD-ROM into a CD drive.

⇒

<SETUP DISK START UP SCREEN> appears.

2. Click [INSTALL PRODUCTS].

3. Click [ScandAll 21] on the window below.

4. Select a language used for installation on

[Choose Setup Language] window and click

[OK].

5. Install the application following the instructions

on the window.

fi-4530C Image Scanner Getting Started