Fujitsu fi-5220C 시작하기 매뉴얼 - 페이지 14

{카테고리_이름} Fujitsu fi-5220C에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-5220C 29 페이지. Flatbed scanner
Fujitsu fi-5220C에 대해서도 마찬가지입니다: 시작하기 (28 페이지), 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 설치 절차 (3 페이지), 사양 (2 페이지), 사용 설명서 (13 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)

페이지 인쇄

The factory default setting for SCSI ID is

"5". If the SCSI ID of another SCSI device is

HINT

set to the same ID, change either the scan-

ner's SCSI ID or SCSI ID of the other SCSI

device. Set the SCSI ID using the SCSI ID

switch on the back of the scanner.

Click

2.3 Installing the Scanner

Application

For scanning documents with this scanner, both scanner

driver and image capturing application software (called

"application" hereafter) must be installed on your PC.

The following scanner drivers and applications are pro-

vided:

• Scanner Driver:

FUJITSU TWAIN 32 Scanner Driver

FUJITSU ISIS Scanner Driver

• Scanning application:

ScandAll PRO (for FUJITSU TWAIN 32)

QuickScan Pro

Install the appropiate scanner driver for the application

you will use. The following sections descri be installa-

tion of each driver and application.

For FUJITSU TWAIN32 Scanner Driver

■ Preparation

Confirm the following items before installing the appli-

cation.

• Take out the Setup CD-ROM from its pack-

age, but do not insert the Setup CD-ROM

into the CD driver yet.

• Connect the scanner correctly to your PC.

For details on how to connect the scanner,

refer to "2.2 Connecting the Scanner to

HINT

Your PC" on page 4.

• Uninstall any older versions of FUJITSU

TWAIN 32 driver if already installed.

(for FUJITSU ISIS)

Uninstall [Scanner Utility for Microsoft Win-

ATTENTION

dows] from [Add/Remove Programs] of the

control panel.

■ Installing the FUJITSU TWAIN32

Scanner Driver

Windows XP screenshots are used in this sec-

tion as examples. The windows and opera-

HINT

tions may slightly vary, if your OS is other than

Windows XP.

1. Press the power button to turn on the scanner.

2. Turn on your PC and log on to Windows.

Be sure to log on as a user with "Administra-

ATTENTION

tor" privileges.

3. If the scanner is automatically detected,

[Found New Hardware Wizard] or [Add/

Remove Hardware Wizard] dialog box will

appear. Click [Cancel] to close the Wizard win-

dow.

4. Insert the Setup CD-ROM into the CD drive.

⇒

appears.

This screen may not appear when the

ATTENTION

"Autoplay" setting of your PC is off. In this

case, run "Install.exe" in this CD-ROM directly

from the "Explorer" or "My Computer".