1.3 Operator panel
The operator panel is located on the right side of the
scanner. The panel consists of a Function Number Dis-
play, four buttons and a LED.
.
Name
Function Number
Display
But-
Function
tons
Send to
Scan
Power button
LED
-
*) About the settings on the launcher, refer to FUJITSU
TWAIN32 scanner driver help and the "fi-5530C
Operator's Guide" on the Setup CD-ROM.
2
Function No.
display
Function
Send to
Scan
Power button
LED
Function
Indicates the state of the scan-
ner. The meaning of the num-
bers and alphabets indicated are
explained later in this section.
Changes the Function activated
by the Send to button (*).
Launches the linked application
software (*).
Turns the scanner ON and OFF.
Lights when the scanner is
turned ON.
■ Indications on the Function
Number Display
The following shows the indications on the Function
Number Display.
Indication
Lights only one time upon turning on the
8
scanner.
Indicates that the scanner has been turned
P
ON and is being initialized.
Indicates that initialization will soon be
0
completed.
Indicates that initialization has been com-
1
pleted successfully.
This status is called "Ready Status".
Indicates that a temporary error (that users
U
can solve) has occurred during the initial-
ization or scanning of documents.
"U" and an error number (1, 2, 6) are dis-
played alternately.
To return the scanner to the ready status
("1"), press the "Scan" or "Send to" button
while the error is indicated.
Indicates that a device alarm (that users can
E
not solve) has occurred during the initial-
ization or
scanning of documents.
"E" and an alarm number (2 to 9, and, c, d,
F) are indicated alternately.
To return the scanner to the ready status
("1"), press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and
then on again. If the alarm is indicated after
turning on the power again, contact your
service engineer.
Meaning
페이지 인쇄