Fujitsu FI-5530C2 시작하기 - 페이지 23

{카테고리_이름} Fujitsu FI-5530C2에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-5530C2 28 페이지. Image scanner
Fujitsu FI-5530C2에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (6 페이지), 사양 (2 페이지), 시작하기 매뉴얼 (27 페이지), 시작하기 매뉴얼 (11 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지), 시작하기 (11 페이지)

페이지 인쇄

Symptom

Paper is not fed (pick error

occurs frequently, or docu-

ment stops midway).

The generated images are

elongated.

There is a shadow on the

leading edge of the gener-

ated image?

Check this item

Do the documents satisfy the "Docu-

ment Quality" and the "Multi feed

Detection Conditions" in the chapter 6

of "fi-5530C2 Operator's Guide"?

Is the Pick roller dirty?

Is the Pick roller worn out?

Is there any debris on the document feed

path?

Are the Feed rollers dirty?

Have you adjusted the scan scale?

Are the Feed rollers dirty?

Have you adjusted the offset (the scan-

ning starting position)?

fi-5530C Image Scanner Getting Started

Remedy

Use the documents that satisfy the "Document

Quality" and the "Multi feed Detection Condi-

tions" in the chapter 6 of "fi-5530C2 Operator's

Guide."

Clean the Pick roller. For details, refer to section

3.2 "Cleaning the ADF"of "fi-5530C2 Operator's

Guide."

Clean the Pick roller. For details, refer to section

4.3 "Replacing the Pick Roller" of "fi-5530C2

Operator's Guide."

Remove any debris from the document feed path.

Clean the Feed rollers. For details, refer to section

3.2 "Cleaning the ADF"of "fi-5530C2 Operator's

Guide."

Select "Scanners and Cameras" in the control

panel, then click the [Device Set] tab to adjust

scale.

Clean the Feed rollers. For details, refer to section

3.2 "Cleaning the ADF"of "fi-5530C2 Operator's

Guide."

Adjust the [Sub-scan Setting] on [Scanners and

Cameras] in the control panel.

AP-2