Fujitsu FI-5530C2 시작하기 - 페이지 5

{카테고리_이름} Fujitsu FI-5530C2에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-5530C2 11 페이지. Image scanner
Fujitsu FI-5530C2에 대해서도 마찬가지입니다: 시작하기 (28 페이지), 설치 절차 매뉴얼 (6 페이지), 사양 (2 페이지), 시작하기 매뉴얼 (27 페이지), 시작하기 매뉴얼 (11 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)

페이지 인쇄

2.2 Connecting the Scanner to

Your Personal Computer

Connect either with the USB interface cable or the SCSI

interface cable.

This scanner is provided with two inter-

ATTENTION

faces: Ultra SCSI and USB 2.0 /1.1. Con-

nect only one of the USB or SCSI interface

cable.

■ Connecting with the USB

Interface Cable

1. Connect the USB interface cable to the USB

interface connector.

2. Connect the other end of the USB interface

cable to your personal computer.

•

Be sure to use the USB cable which

ATTENTION

comes with this scanner. Correct opera-

tion with commercially available cables

is not guaranteed.

•

When connecting to an USB hub, use

the first stage USB hub that is closest to

the computer. If you use the second or

later hub stages, the scanner may not

operate correctly.

•

If you connect the scanner with USB 2.0,

it is required that the USB port and Hub

are compliant with USB 2.0. The scan-

ning speed will slow down if it is con-

nected with USB1.1.

■ Connecting with the SCSI Inter-

face Cable

When using the scanner with a SCSI interface, the fol-

lowing SCSI interface cable and SCSI card must be pur-

chased.

• SCSI interface cable:

Use a cable which complies with a 50 Pin Con-

tact Shielded High-Density SCSI Device Con-

nector for Ultra SCSI.

• SCSI card

Find the recommended SCSI card information in

the Fujitsu web site (FAQ).

http://imagescanner.fujitsu.com/

•

When connecting the SCSI interface

ATTENTION

cable, turn the scanner off. Be sure to

connect the SCSI interface cable first ,

and then turn on the power of the scan-

ner and personal computer.

•

In a SCSI daisy chain formation, con-

nect the scanner so that it is the termi-

nated device.

1. Insert the SCSI interface cable into the inter-

face connector of the scanner until both sides

click.

2. Connect the other end of the cable to your per-

sonal computer.

Be careful not to bend the pins of the SCSI

ATTENTION

cable when connecting to the scanner .