Brother MFC-790CW 빠른 설정 매뉴얼 - 페이지 24

{카테고리_이름} Brother MFC-790CW에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-790CW 44 페이지. Quick setup guide - spanish
Brother MFC-790CW에 대해서도 마찬가지입니다: (영어) 빠른 구성 가이드 (50 페이지)

페이지 인쇄

1. Go to

Wired Network

For Wired Network Interface Users (For Mac OS

Before you install

Make sure your machine is connected to the

power and your Macintosh

be logged on with Administrator rights.

Important

• For Mac OS

X 10.2.0 to 10.2.3 users,

upgrade to Mac OS

the latest information for Mac OS

http://solutions.brother.com/)

• Make sure there are no memory cards or a

USB Flash memory drive inserted.

• If you have previously set up your machine

for a wireless network and then want to set

it up on a wired network, you should check

that the machine's Network I/F is set to

Wired LAN. The wireless network interface

will be inactive with this setting. On your

machine, press MENU.

Press a or b to display Network and press

Network.

Press Network I/F.

Press Wired LAN.

Press Stop/Exit.

Connect the network

cable

Using both hands, use the plastic tabs on both

sides of the machine to lift the scanner cover

until it locks securely into the open position.

is ON. You must

X 10.2.4 or greater. (For

X, visit

Macintosh

X 10.2.4 or greater)

Connect the network cable to the LAN socket

marked with a

LAN socket inside the machine on the left as

shown below.

LAN

USB

Carefully guide the network cable to the trench

as shown below, following the trench around

and toward the back of the machine. Then,

connect the cable to your network.

Important

Make sure that the cable does not restrict the

cover from closing, or an error may occur.

Note

If both USB and LAN cables are being used,

guide both cables through the trench with one on

top of the other.

Lift the scanner cover to release the lock a.

Gently push the scanner cover support

down

and close the scanner cover c.

symbol. You will find the