Brother MFC-790CW 빠른 설정 매뉴얼 - 페이지 29

{카테고리_이름} Brother MFC-790CW에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-790CW 44 페이지. Quick setup guide - spanish
Brother MFC-790CW에 대해서도 마찬가지입니다: (영어) 빠른 구성 가이드 (50 페이지)

페이지 인쇄

1. Go to

For Wireless Network Users

Connecting the Brother machine to the wireless network

Configure the wireless

settings (Typical

Wireless Setup in

infrastructure mode)

On your machine, press MENU.

Press a or b to display Network and press

Network.

Press WLAN.

Press Setup Wizard.

When Switch Network interface to

wireless? is displayed, press Yes to accept.

This will start the wireless setup wizard.

To cancel, press No.

The machine will search for available SSIDs. If

a list of SSIDs is displayed, press a or b to

choose the SSID you wrote down in step 15 on

page 28. Press the SSID you want to connect

with. Go to f.

Note

It will take several seconds to display a list of

available SSIDs.

If your access point is set to not broadcast the

SSID you will have to manually add the SSID

name. Go to c.

Press <New SSID>. Go to d.

Enter the SSID you wrote down in step 15 on

page 28 using the Touchscreen.

You can use the d and c keys to move the

cursor left and right.

The letters appear in this order: lower case and

then upper case.

To enter numbers or special letters, press

repeatedly until the character you want to enter

appears.

(For more information, see Entering Text for

Wireless Settings on page 43.)

Press OK when you have entered all the

characters.

Press Infrastructure.

Choose one of the options below: If your

network is configured for Authentication and

Encryption you must match the settings used

for your network.

No Authentication or Encryption:

Press Open System, then press None for

Encryption Type? Then press Yes to

apply your settings. Go to i.

No Authentication with WEP Encryption:

Press Open System, then press WEP for

the Encryption Type? Go to g.

Authentication with WEP Encryption:

Press Shared Key. Go to g.

Authentication with WPA/WPA2-PSK

(TKIP or AES) Encryption:

Press WPA/WPA2-PSK. Go to h.

Choose the appropriate key number. Enter the

WEP key you wrote down in step 15 on

page 28 on the Touchscreen.