Fujitsu FI-6000NS 시작하기 매뉴얼 - 페이지 30

{카테고리_이름} Fujitsu FI-6000NS에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-6000NS 35 페이지. Fujitsu fi-6000ns: user guide
Fujitsu FI-6000NS에 대해서도 마찬가지입니다: 사양 (2 페이지)

페이지 인쇄
Fujitsu FI-6000NS 시작하기 매뉴얼
Appendix D

■ Checking Basic Network Operation with a Ping Test

If a network connection is not possible, refer to "3.8 Checking the Network Connection" (page 9) for ping results and
how to deal with them.
Result
"Ping statistics" shows "Lost=0
(0% loss)"
"Ping statistics" shows "Lost=4
(100% loss)"
"Ping statistics" shows "Lost=N
(1 to 99% loss)"
"Hardware error"
"Ping request could not find
host xxx.xxx.xxx. Please check
the name and try again."
OK: Connection is operating normally. NG: Connection is faulty.
16
Network Connection Troubleshooting
Server
Connection
name
status
setting
IP address /
OK
server name
IP address /
NG
server name
IP Address
Server name
NG
IP address /
server name
IP address /
server name
NG
IP address /
server name
NG
Server name
Action
None
Check that the ping target IP address or server name is
correct.
If the ping target IP address is correct, refer to "Failure
to Connect to a Remote Computer using its IP Address"
(page 17) for further solutions.
On the "Network Status" screen, change [Link speed /
Duplex mode] from "Auto-Negotiation" to a fixed mode.
This can be changed as follows:
1.
Select the [Network Settings] tab on the top menu.
2.
Press the [Down] button on the left side menu.
3.
Select the [Network Status] tab on the left side
menu.
4.
On the "Network Status" screen, select [Link
Speed/Duplex Mode].
5.
Press the [OK] button.
There may be a problem with the quality of the LAN
cable. Replace the LAN cable and try again.
On the "Network Status" screen, change [Link speed /
Duplex mode] from "Auto-Negotiation" to a fixed mode.
This can be changed as follows:
1.
Select the [Network Settings] tab on the top menu.
2.
Press the [Down] button on the left side menu.
3.
Select the [Network Status] tab on the left side
menu.
4.
On the "Network Status" screen, select [Link
Speed/Duplex Mode].
5.
Press the [OK] button.
The LAN cable may have become disconnected during
the Ping test. Check the status of the LAN cable and try
again.
Check that the ping target server name is correct.
Check that the DNS server or WINS server settings are
correct.
If the ping target server name is correct, refer to "Failure
to Connect to a Remote Computer using its Server
Name" (page 18) for further solutions.