Fujitsu FI-6240 시작하기 - 페이지 19

{카테고리_이름} Fujitsu FI-6240에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-6240 23 페이지. Image scanner
Fujitsu FI-6240에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (6 페이지), 사양 (2 페이지), 시작하기 매뉴얼 (20 페이지), 사용 설명서 (10 페이지)

페이지 인쇄

Appendix1

■ Troubleshooting checklist

Symptom

Scanner does not turn on.

Scanning does not start.

fi-6140/fi-6240/fi-6130/fi-6230 Image Scanner Getting Started

TROUBLESHOOTING

Check this item

Have you pressed the power button on?

Are the AC cable and AC adapter

properly connected to the

scanner?

Is Windows normally started up?

Are the documents loaded correctly on the

ADF paper chute?

Is the ADF closed completely?

Is the USB cable or SCSI cable properly

connected?

(When using SCSI interface) Is SCSI ID

set correctly?

Does the Function Number Display

indicates an alarm or an error?

Does the alarm state remain displayed

even after the scanner has been turned off

and back on again?

Push the power button.

Correctly connect the AC cable and the AC adapter.

Disconnect the AC cable and the AC adapter from

the scanner, then connect them again.

If this does not restore the power supply, contact

the store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

Push the power button again after completely

starting up Windows.

Load the document correctly on ADF paper chute.

Close the ADF completely.

Correctly connect the cable. (When a USB hub is

used, check the hub's power supply.)

Set SCSI ID correctly by SCSI ID switch on rear of

scanner.

When the Function Number Display indicates an

alarm or an error, refer to chapter 6 "Troubleshoot-

ing" of "fi-6140/fi-6240/fi-6130/fi-6230 Operator's

Guide" for removing the alarm or the error.

Turn off and on the power button.

If this does not eliminate the alarm state, contact the

store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

AP-1

Remedy