Fujitsu fi-65F 시작하기 매뉴얼 - 페이지 4

{카테고리_이름} Fujitsu fi-65F에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-65F 6 페이지. Image scanner
Fujitsu fi-65F에 대해서도 마찬가지입니다: 시작하기 (7 페이지)

페이지 인쇄
Fujitsu fi-65F 시작하기 매뉴얼
■ Installation (Custom)
1.
Perform steps
1.
(Recommended) (page
2.
Click the [Installation (Custom)] button.
3.
Select the check box for the software to
install and click the [Next] button.
4.
Follow the instructions on the screen to
proceed with the installation.

Installing the Scanner

Install the scanner in the following procedure.
1.
Place the scanner at its installation site.
ATTENTION
Carry the scanner by supporting it from the
bottom.
Outer dimensions
Installation space
145 (5.71)
145 (5.71)
2.
Unlock the transport lock switch.
There is a carrier unit inside the flatbed which
is fixed in place to prevent damage during
transportation.
Slide the transport lock switch on the back.
Locked
to
2.
in
"Installation
3)".
257
(10.12)
40 (1.57)
281
234
(11.06)
(9.21)
Unit: mm (in.)
Unlocked
Transport lock switch

Connecting the Cables

Connect each cable in the following procedure.
2
USB connector
USB cable
CAUTION
Only use the supplied AC adapter. Not doing
so may cause the scanner to malfunction.
Furthermore, do not use the supplied AC
adaptor for other products.
1.
Confirm that the computer is turned off.
2.
Connect the USB cable to the USB
connector of the scanner and USB port of
the computer.
ATTENTION
Use the supplied USB cable.
When you use a USB hub, a USB 2.0
certified hub is recommended. If the
scanner that is connected to the USB hub
does not operate properly, connect the
USB cable to the USB port of the
computer directly.
If you connect the scanner with USB 2.0,
it is required that the USB port be
compliant with USB 2.0. The scanning
speed slows down when you connect the
scanner with USB 1.1.
Connect it with
the USB mark
facing up.
4
Power connector
AC adapter
3
3
AC cable
USB bus power cable
3
1
2
USB mark