Fujitsu fi-6770 Series 시작하기 매뉴얼 - 페이지 22

{카테고리_이름} Fujitsu fi-6770 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-6770 Series 26 페이지. Image scanner
Fujitsu fi-6770 Series에 대해서도 마찬가지입니다: 사용자 설명서 (26 페이지), 설치 절차 매뉴얼 (6 페이지), 브로셔 (2 페이지), 시작하기 매뉴얼 (14 페이지), 소모품 교체 및 청소 지침 (22 페이지)

페이지 인쇄

Test-Scanning Documents

Using ScandAll PRO, you can test-scan documents to check if they are scanned with the ADF correctly.

For how to scan documents with the flatbed, refer to "Chapter 4 Various Documents" in the Operator's

Guide.

The following describes how to test-scan a document:

Turn on the scanner.

1) Press the "I" side of the main power switch of the scanner.

2) Press the [Power] button on the Operator Panel.

The scanner is turned ON, and the Power LED on the Operator Panel lights in green.

Note that while the scanner is being initialized, the indication of the Function Number Display

changes as; "8"

Turn on your computer.

The scanner is automatically detected, and

the [Found New Hardware] dialog box

appears.

Select [Locate and install driver software

(recommended)] to install the driver,

following the on-screen instructions.

"P"

"1", where "1" means that the Operator Panel is in the Ready Status.

If you see an error indication other than the above on the Function Number Display, refer to

"Chapter 7 Troubleshooting" in the Operator's Guide.

Ex. :If "U" is displayed on the Function Number Display, it means that the Transport Lock

remains locked. In such case, you need to unlock the Transport Lock.

For how to unlock the Transport Lock, refer to "Section 2 Installing the Scanner" (on page 13).

ADF type

Operator Panel

Function

Scan / Stop

Check

Send to

Function Number Display

For a SCSI connection, turn on the scanner and confirm that the Function Number Display

shows "1." Then, turn on your computer.

Flatbed type

Power

[Power] button