Fujitsu Fujitsu fi-5950 시작하기 - 페이지 14

{카테고리_이름} Fujitsu Fujitsu fi-5950에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Fujitsu fi-5950 27 페이지. Image scanner
Fujitsu Fujitsu fi-5950에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 소모품 교체 및 청소 지침 (24 페이지), 시작하기 (11 페이지)

페이지 인쇄

■ Connecting the SCSI interface

When using the scanner with a SCSI interface, the fol-

lowing SCSI cable and SCSI card must be purchased.

• SCSI cable

Use a SCSI cable whose connector on the scan-

ner side is the 68-pin high-density shielded-type

and whose connector on the PC side fits the con-

nector of the SCSI card to use.

It is recommended to use a cable of length 1.5 m

or shorter.

• SCSI card

Find the recommended SCSI card information

on the Fujitsu web site (FAQ).

http://www.fujitsu.com/global/support/

computing/peripheral/scanners/scsi/

•

When connecting the SCSI cable, turn

ATTENTION

the scanner off. Be sure to connect the

SCSI cable first, and then turn on the

power of the scanner and PC.

•

In a SCSI daisy chain configuration,

connect the scanner so that it is the ter-

minated device.

1. Insert the SCSI cable into the interface connec-

tor of the scanner until both sides click.

2. Connect the other end of the cable to your PC.

Be careful not to bend the pins of the SCSI

ATTENTION

cable when connecting to the scanner.

3. Set the SCSI ID using the SCSI ID switch on

the back of the scanner.

The SCSI ID is initially set to "5" at the factory.

If the SCSI ID of another SCSI device is set to the

same ID, either change the scanner's SCSI ID or

SCSI ID of the other SCSI device.

ID No.

0 to 7

Can be set as the ID

Works with the factory default value

8, 9

(SCSI ID = 5).

When the scanner is turned on, the SCSI ID set is

enabled.

4. Press the "I" side of the main power switch to

turn on the scanner.

■ When using Kofax VRS Profes-

sional (hereinafter referred to as

"Kofax VRS")

When using the Kofax VRS, you need to connect it to

the exclusive VRS board with either the USB cable or

SCSI cable.

1. If you use the USB cable, insert it into the inter-

face connector (1) shown below.

If you use the SCSI cable, insert it into the

interface connector (2) shown below.

SCSI ID Switch

2. Connect the other end of the cable to your PC.

Description

OFF

VRS board