Fujitsu M3093DX 설치 절차

{카테고리_이름} Fujitsu M3093DX에 대한 설치 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu M3093DX 5 페이지.

M3093GX\DG\M3096G\GX\M3097G+\DG

Fi-4340C\Fi-4530C\Fi-4640S\M4097D\Fi-4750C\L\Fi-5750 SCSI

Step A: Required hardware.

To install these models you will need a Narrow SCSI 50-pin controller and six foot (maximum)

Narrow SCSI cable.

Step B: Removing the shipping bracket.

It is recommended that before you connect the scanner to your computer that you inspect the

scanner and remove the shipping bracket first.

Removing the shipping bracket: The flatbed scanner models typically come with a

factory installed shipping lock designed to protect the scanner during shipment. Before

the scanner can be used the shipping lock must be unlocked. Follow these instructions

to unlock the shipping bracket:

1. Slide the scanner to its side as shown in figure below.

2. Unscrew the retainer screw and remove the shipping bracket.

3. Place the shipping bracket in the "use position" slot and secure it with the retainer

screw (see figure below)

Place scanner back in its normal position

Win95\98\ME Installation Procedure

Rev052104A