Fujitsu M3096E+ 운영자 매뉴얼 - 페이지 36

{카테고리_이름} Fujitsu M3096E+에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu M3096E+ 45 페이지. Image scanner

4.4.2

Automatic document feeding (E type only)

When the document

is read in the automatic

document

feed mode, follow the steps

below. If these steps are not closely followed, a feed error may occur.

Place the document upside down.

Arrange the document as shown below. (See the next page.)

End

Open the right

and left guides

of the ADF paper

chute,

and

set them

approximately

5 mm wider than the document width.

Position the document face down and put the ends of the lower 2 or 3 sheets into

the auto feeder hole.

Line up the guides with the document

sides.

(Skewing may occur if there is a

gap between the guides and document.)

Slide the pages down until they hit the far end of the auto feeder hole.

Position the remaining

document sheets on the paper chute.

Insert these sheets until they hit the far end of the auto feeder hole.

4-10

50FH5020E-01