Fujitsu M3096F+ 운영자 매뉴얼 - 페이지 29
{카테고리_이름} Fujitsu M3096F+에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu M3096F+ 45 페이지. Image scanner
페이지 인쇄Table 4.1
Switch names and functions
Switch name
Indication
Function
start switch
None
If, in the manual mode, this switch is pressed while the
Ready lamp is lit, the read operation is started.
If this switch is pressed while reading:
Flat-bed:
The read operation is immediately interrupted
and the carrier returns to the home position.
ADF:
The read operation is immediately interrupted
stop switch
None
and paper that has been fed is ejected. Paper
that has been loaded into the scanner but not
yet read is ejected. If this switch is pressed
after
a
jam is cleared, the jam lamp goes out
and reading is enabled.
Resolution
switch
Yes
Sets the resolution.
Each time this switch is pressed, the
resolution lamps light in turn, as shown below.
400 ----)
300 -
240 -
200
Document
switch
Half-tone
switch
Yes
Yes
Document reading is selected. Each time this switch is
pressed, the "Line" and "Photo" lamps light alternately.
Enables half-tone processing.
Each time this switch is
pressed, the "Half-tone" lamp lights and goes out
alternately.
Density is set. Each time this switch is pressed, the
density lamps light in turn, as shown below.
(When using the option base only)
Density switch
Yes
Size switCh
Yes
Auto
v-+
Dark d
(Somewhat
Normal +
(Somewhat
Light -
dark)
light)
Sets the document size. Each time this switch is pressed,
the Size lamps light in turn, as shown below.
11x17+
A4+
8-1/2X11
-W
B4--,
8-l/!Jxll
ADF switch
Yes
Specifies
whether reading is done with the ADF or from
the flat-bed. Each time this switch is pressed, the ADF
lamp lights and goes out alternately.
Landscape
Yes
Specifies whether reading is done in the portrait mode or
landscape mode. Each time this switch is pressed, the
Landscape lamp lights and goes out alternately.
60FH5020E-01
4-3
-