Fujitsu PA03338-B005 - FI-5750C Image Scanner 시작하기 매뉴얼 - 페이지 39

{카테고리_이름} Fujitsu PA03338-B005 - FI-5750C Image Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PA03338-B005 - FI-5750C Image Scanner 42 페이지. Image scanner

페이지 인쇄

Appendix 4 Setting the

position of the

ADF

As the factory default, ADF of fi-5750C is

fixed with ADF lock screws. Be sure to remove

the screws before changing the position of the

ADF.

ADF can be set to the following three posi-

tions:

•

Type 1: Traditional

-Traditional style of previous FUJITSU scanner

products

-For operators accustomed to previous FUJITSU

scanners

•

Type 2: Standard

- Small foot print

- For right-handed operators

•

Type 3: Reversed

- Small foot print

- For left-handed operators

Type 2 and 3 are available only when the ADF

is set to the center position. Before changing

the ADF position to Type 2 or 3, slide the ADF

to the center position. When the ADF is in

Type 2 position, you can change the position to

Type 3 by rotating the ADF in 180 degrees and

vice versa.

For details on setting the ADF, refer to 2.2

"Setting the ADF" of "fi-5750C Operator's

Guide" on Manual CD-ROM.

CAUTION

• Please rotate the ADF after you

ATTENTION

set the stacker upright.

• When you change the position of

the ADF, do not rotate it over 180

degrees, other wise the ADF may

be damaged.

Take care not to pinch your

fingers when rotating the ADF.

AP-9