Fujitsu PA03420-B001 - fi 60F - Flatbed Scanner 시작하기 - 페이지 18

{카테고리_이름} Fujitsu PA03420-B001 - fi 60F - Flatbed Scanner에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PA03420-B001 - fi 60F - Flatbed Scanner 20 페이지. Image scanner

페이지 인쇄

Symptom

When the document is

scanned in Black &

White mode, the image

generated becomes

black.

Automatic paper size

detection is failed.

AP-2

Check this item

Are the Document holding pad and

the Document bed of the scanner

clean?

Have you tried to adjust the set-

tings of the scanner driver (Thresh-

old or Brightness)?

Did you scan a document so thin

that the contents of the backside

can be seen through?

Are the Document holding pad and

the Document bed of the scanner

clean?

Did you scan with the document

cover closed?

Is the document rectangular or

square in shape?

Did you scan a document with any

corner folded?

Did you scan a document with

dark-colored edge(s)?

Remedy

Clean the dirty locations as instructed in the

Operator's Guide "2. Daily Care".

Adjust the Threshold and/or Brightness.

Place a piece of white paper behind the

document and scan again.

- When there are any contents such as

characters on the backside of the docu-

ment, they may be seen through and

appear in the scanned.

- When using "Automatic Size and Skew

detection", place a piece of white paper

of the same size as the document

behind the document.

Clean the dirty locations as instructed in the

Operator's Guide "2. Daily Care".

Close the document cover and scan it

again.

If the document is other than rectangular or

square, the scanner may fail to detect the

size correctly.

Specify the area to scan in the driver set-

ting window manually and scan it again.

If the corner is folded, unfold it.

If the document has dark-colored edge(s),

the scanner may fail to detect the size cor-

rectly.

Specify the area to scan in the driver set-

ting window manually and scan it again.