Brother DCP-7045N 빠른 설정 매뉴얼 - 페이지 6

{카테고리_이름} Brother DCP-7045N에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-7045N 32 페이지.
Brother DCP-7045N에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (18 페이지), 빠른 설정 매뉴얼 (32 페이지)

페이지 인쇄

Safety Precautions

Regulations

EC Declaration of Conformity

IEC60825-1+A2:2001 Specification

This machine is a Class 1 laser product as defined in

IEC60825-1+A2:2001 specifications. The label

shown below is attached in countries where required.

This machine has a Class 3B Laser Diode which

emits invisible laser radiation in the Scanner Unit. The

Scanner Unit should not be opened under any

circumstances.

Internal laser radiation

Wave length: 780 - 800 nm

Output: 10 mW max.

Laser Class: Class 3B

Warning

Use of controls, adjustments or performance of

procedures other than those specified in this

manual may result in hazardous radiation

exposure.

CLASS 1 LASER PRODUCT

APPAREIL À LASER DE CLASSE 1

LASER KLASSE 1 PRODUKT

Disconnect device

This product must be installed near an electrical

socket that is easily accessible. In case of

emergencies, you must disconnect the power cord

from the electrical socket to shut off power

completely.

Wiring information (U.K. only)

If you need to replace the plug fuse, fit a fuse that is

approved by ASTA to BS1362 with the same rating as

the original fuse.

Always replace the fuse cover. Never use a plug that

does not have a cover. If in any doubt, call a qualified

electrician.

Warning - This printer must be earthed.

The wires in the mains lead are coloured in line with

the following code:

Green and Yellow: Earth

Blue: Neutral

Brown: Live

LAN connection (DCP-7045N only)

Caution

DO NOT connect this product to a LAN connection

that is subject to over-voltages.

Radio interference

This product complies with EN55022 (CISPR

Publication 22)/Class B. When connecting the

machine to a computer, ensure that you use the

following interface cables.

A USB cable which must not exceed 2.0 metres in

length.

EU Directive 2002/96/EC and EN50419

This equipment is marked with the above recycling

symbol. It means that all the end of the life of the

equipment you must dispose of it separately at an

appropriate collection point and not place it in the

normal domestic unsorted waste stream. This will

benefit the environment for all. (European Union only)