Fujitsu S300M - ScanSnap - Document Scanner 시작하기 매뉴얼 - 페이지 30
{카테고리_이름} Fujitsu S300M - ScanSnap - Document Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu S300M - ScanSnap - Document Scanner 38 페이지. Color image scanner
Fujitsu S300M - ScanSnap - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 청소 지침 (2 페이지)
페이지 인쇄
Chapter 4 Troubleshooting
This chapter describes common problems during the usage of the ScanSnap and how to
remedy them.
4.1 Troubleshooting Checklist
Before you ask for repair service, please check the following items.
If you cannot solve the problem even after checking the following items, contact the store
where you purchased the ScanSnap, or contact an authorized FUJITSU scanner service
provider.
Symptom
The
Is the AC/USB cable and the
ScanSnap
AC adapter connected
cannot be
correctly?
turned on.
Is the paper chute closed?
(The ScanSnap is
automatically powered on/off
when the paper chute is
opened/closed.)
Is the Mac OS started
completely? (This ScanSnap
is powered on/off in
conjunction with the
computer.)
29
For troubleshooting errors caused during operation, refer to "7.2
Troubleshooting Checklist" of "ScanSnap S300M Operator's Guide."
* Visit our Web site for your reference. Other useful information will be
posted on the FAQ corner at the following Web site:
http://scansnap.fujitsu.com/
Check This Item
Remedy
Correctly connect the power or USB cable
and USB bus power cable to the computer.
When using a hub, check the hub's power
supply.
When using a USB bus power cable, use a
powered USB hub equipped with an AC
adapter. If you connect to a non-powered
hub, the ScanSnap may not work properly.
Disconnect and then re-connect the power
or USB bus power cable.
(Note: Wait at least five seconds before
reconnecting the Power/USB bus power
cable)
Open the paper chute cover.
Wait until Mac OS X has started up
completely. The
Mac OS X is starting up or in the sleep
mode.
LED stays out while