Fujitsu ScanSnap iX500 빠른 시작 매뉴얼

{카테고리_이름} Fujitsu ScanSnap iX500에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iX500 2 페이지. Windows
Fujitsu ScanSnap iX500에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (17 페이지), 시작하기 매뉴얼 (16 페이지), 빠른 설정 매뉴얼 (3 페이지), 시작하기 (18 페이지), 안전 주의사항 (11 페이지), 매뉴얼 (2 페이지), Wi-Fi 연결 매뉴얼 (41 페이지)

Are the mobile device and the ScanSnap iX500 connected to the same

wireless LAN?

[Resolution]



Make sure that the Wi‐Fi switch at the backside of ScanSnap iX500 is "ON" and the

Wi‐Fi lamp at the front side is lighting in "blue".

If the Wi‐Fi lamp is lighting in orange, the wireless access point and ScanSnap iX500 are

not connected properly. Check the following items:

Make the distance shorter between the ScanSnap iX500 and the wireless

access point.

Change an angle of ScanSnap iX500.

If there are any obstacles (wall, metal plate, etc.) and/or noise sources

(Microwave, cordless telephone, wireless devices, etc.) between ScanSnap

iX500 and the wireless access point, avoid or remove them.

Connect ScanSnap iX500 to a computer via USB, and either perform a wireless

setting using the ScanSnap Wireless Setup Tool, or follow the direction of the

wireless diagnosis result.



Close the ADF paper chute (cover) of ScanSnap iX500 to turn it off. Then, turn the

ScanSnap iX500 on again.



Turn on/off the wireless access point to reset it.



Check the network setting of the mobile device. If the ScanSnap iX500 is not connected

to the same network as the mobile device, connect the ScanSnap iX500 to the network

that the mobile device is connected to.

Back side