Fujitsu ScanSnap S1300 안전 주의사항 - 페이지 8
{카테고리_이름} Fujitsu ScanSnap S1300에 대한 안전 주의사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap S1300 9 페이지. Color image scanner
Fujitsu ScanSnap S1300에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 시작하기 매뉴얼 (8 페이지), 시작하기 매뉴얼 (9 페이지), 사양 (3 페이지)
페이지 인쇄
For ScanSnap S1300 Users
■ Bus Power Use Restrictions
When using a computer as the power supply for the ScanSnap:
The ScanSnap does not work properly if you connect it to a non-powered USB hub.
The ScanSnap does not work properly if you connect it to the USB port of a PC card.
The ScanSnap may not work properly if you connect the USB bus power cable and USB cable to
different computers or powered USB hubs.
The ScanSnap may not work properly if you connect another USB-powered device to any of the
USB ports of the computer.
Depending on the USB power supply capability of the computer, other USB-powered devices con-
nected to the computer may be affected.
Regulatory Information
FCC Declaration
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
document, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is located.
Consult your dealer or an experienced radio/TV technician.
FCC warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTICE
The use of a shielded interface cable is required to comply with the Class B limits of Part
15 of FCC rules. The length of the power cable must be 3 meters (10 feet) or less.
Canadian DOC Regulations
This digital apparatus does not exceed the Class B limit for radio noise emissions from digital apparatus
set out in the Radio interference Regulations of the Canadian Department of Communications.
This Class B digital apparatus complies with Canadian ICES-003.
Le présent appareil numérique n'émet pas de parasites radioélectriques dépassant les limites
applicables aux appareils numériques de la classe B et prescrites dans le Règlement sur le brouillage
radioélectrique dictées par le Ministère des Communications du Canada.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
8