Fujitsu ScanSnap S1300i 시작하기 - 페이지 5
{카테고리_이름} Fujitsu ScanSnap S1300i에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap S1300i 10 페이지. Color image scanner
Fujitsu ScanSnap S1300i에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (9 페이지), 사양 (3 페이지), 시작하기 (10 페이지), 안전 주의사항 (11 페이지), 매뉴얼 (2 페이지)
페이지 인쇄
ATTENTION
If the system requirements above are not
satisfied, the ScanSnap may not operate.
Scanning speed will slow down in the following
cases:
- The CPU or the memory does not meet the
required specifications
- The USB port or the USB hub is version 1.1
Installation
1.
Turn on the computer and log on as a user
with Administrator privileges.
2.
Insert the Setup DVD-ROM into the DVD-
ROM drive.
The [ScanSnap] window appears.
3.
Double-click the [ScanSnap] icon.
Follow the instructions on the screen to
continue with the installation.
Connecting the ScanSnap
ATTENTION
Only one ScanSnap can be used by a
computer at a time.
Use only the cables bundled with the
ScanSnap.
CAUTION
To prevent damage to the ScanSnap, use only
the AC adapter bundled with the ScanSnap.
Manufacturer: LEI
Model No.: NU13-1072166-I3
1.
Select a power cable depending on where
you want to use the ScanSnap.
To use the ScanSnap at a fixed location:
Use the power cable to connect to an AC
outlet.
For details about connection, refer to
the Power Cable" (page 6)
AC
adapter
To use the ScanSnap outside with your laptop
computer, or in a place where there are no AC
outlets nearby:
Use the USB bus power cable to connect to
your computer.
For details about connection, refer to
the USB Bus Power Cable" (page 6)
3.
2.
Remove the tape seal covering the USB
connector and power connector of the
ScanSnap.
5
"Using
in Step
3.
AC
cable
"Using
in Step
USB bus
power
cable