Fujitsu SP600C 설치 절차 매뉴얼 - 페이지 2
{카테고리_이름} Fujitsu SP600C에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SP600C 7 페이지. Scsi scanner installation procedures for windows nt 4.0
Fujitsu SP600C에 대해서도 마찬가지입니다: 설치 절차 매뉴얼 (9 페이지)
페이지 인쇄
Fujitsu SCSI Scanner Installation Procedures
11. For Windows 2000 or XP scroll down to the "Enter key word or quoted phrase" box
and type in "aspi".
12. Next scroll down to the drivers section, click on ASPI_v470 or higher and follow the
prompts to download it.
13. Afterwards go to that folder and unzip the file to the default Adaptec\ASPI folder.
14. Then go to start, run, browse to the Adaptec\ASPI folder, select ASPIINST.EXE and
run it.
15. When the message "ASPI is up to date" appears, reboot and go to the next step.
Step C: Installing the drivers from the Setup CD.
To begin it is recommended that you install the drivers first before connecting the scanner.
Installing the STI-Twain driver.
1. Insert the Scanner Setup CD into your CD Rom.
2. Next please complete the pre-registration box when it appears and click the submit
button.
3. Afterwards close your browser and click the Install Products button on the Scanner
Setup Menu.
4. On the next screen click on Twain Driver and you may be presented with the option
to install the Error Recovery Guide.
5. After you have installed the Error Recovery Guide (or not) follow the prompts to
complete the twain driver installation.
6. Do not reboot at this time!
Installing the ASPI-Twain driver.
Some of our scanners are not supported by the STI-Twain drivers. For those units you
must install the ASPI-Twain driver. Please refer to the driver download page to see if
your model is one of them.
7. Insert the Scanner Setup CD into your CD Rom.
8. Next please complete the pre-registration box when it appears and click the submit
button.
9. Afterwards close your browser and click the Install Products button on the Scanner
Setup Menu.
10. On the next screen click on Twain Driver and you may be presented with the option
to install the Error Recovery Guide.
11. After you have installed the Error Recovery Guide (or not) follow the prompts to
complete the twain driver installation.
12. Do not reboot at this time!
Installing the ISIS driver.
13. Next go back to the Scanner Setup Menu and click on ISIS Driver.
14. If you didn't install the Error Recovery Guide during the Twain driver installation you
will be asked again. Proceed and follow the prompts to complete the ISIS driver
installation.
15. Do not reboot at this time!
Rev051906A
Windows 95\98\98SE\ME\2000\XP
Page 2 of 7