Fujitsu DynaMO 2300 사용자 설명서 - 페이지 14

{카테고리_이름} Fujitsu DynaMO 2300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu DynaMO 2300 50 페이지. 3.5-inch magneto-optical disk drive

Changing SCSI ID Setting

You can change the setting by rotating the SCSI ID selector on the back panel. Make sure to power off

the MO Drive before changing the SCSI ID setting.

• Connecting other SCSI devices with the MO Drive

You can connect several SCSI devices to one SCSI host adapter. This is called a SCSI chain. You can

connect up to five other SCSI devices (i.e., color scanner) with the MO drive in a single SCSI chain.

When connecting SCSI devices, the last device in the SCSI chain should be a device with the fastest data

transfer rate.

For any SCSI chain, the total length of all the SCSI cables should not exceed 6 meters. We strongly

recommend that each SCSI cable in the chain does not exceed one meter.

• SCSI ID

A SCSI ID is an address number (0 through 7) assigned to a SCSI device. In a SCSI chain, each device

must have an individual ID number.

The ID number of the MO drive is set to 2 at the factory. In case you have already assigned 2 to another

SCSI device, you have to change the SCSI ID of the MO drive.

• Usual assignment

SCSI ID 0 to the computer's internal boot hard disk (if it is SCSI hard disk).

SCSI ID 7 to the SCSI host adapter itself. (To confirm the SCSI ID of the adapter, please read the user's

guide of your SCSI host adapter.)