Brother HL-4070CDW 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Brother HL-4070CDW에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-4070CDW 13 페이지. Brother color laser printer
Brother HL-4070CDW에 대해서도 마찬가지입니다: 브로셔 (4 페이지), 부품 참조 목록 (40 페이지), 서비스 업데이트 매뉴얼 (11 페이지), 청소 및 관리 (7 페이지)
페이지 인쇄
CHAPTER 3 DISASSEMBLY AND ASSEMBLY
1.
SAFETY PRECAUTIONS
To avoid creating secondary problems by mishandling, follow the warnings and precautions
below during maintenance work.
HOT SURFACE
Some parts inside the machine are extremely hot immediately after the machine is used.
When opening the front cover or back cover to access any parts inside the machine,
never touch the shaded parts shown in the following figures.
Caution:
- Be careful not to lose screws, washers, or other parts removed.
- Be sure to apply grease to the gears and applicable positions specified in this chapter.
- When using soldering irons or other heat-generating tools, take care not to accidentally
damage parts such as wires, PCBs and covers.
- Static electricity charged in your body may damage electronic parts. When transporting PCBs,
be sure to wrap them in conductive sheets.
- When replacing the PCB and all the other related parts, put on a grounding wrist band and
perform the job on a static mat. Also take care not to touch the conductor sections on the flat
cables or on the wire harness.
- After disconnecting flat cables, check that each cable is not damaged at its end or short-
circuited.
- When connecting flat cables, do not insert them at an angle. After insertion, check that the
cables are not at an angle.
- When connecting or disconnecting cable connectors, hold the connector body, not the cables.
If the connector has a lock, release the connector lock first to release it.
- After a repair, check not only the repaired portion but also all connectors. Also check that
other related portions are functioning properly before operational checks.
3-1
Confidential