Fujitsu eternus af 구성 매뉴얼 - 페이지 12

{카테고리_이름} Fujitsu eternus af에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu eternus af 32 페이지. Fibre channel for citrix xenserver
Fujitsu eternus af에 대해서도 마찬가지입니다: 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (43 페이지)

페이지 인쇄

Chapter 3

Notes

Note the following issues when connecting the ETERNUS DX/AF to a server.

3.1

Installation Notes

To ensure reliable access to ETERNUS DX/AF storage systems, multipath configuration is recommended.

•

Setting up multiple access paths between the server and the ETERNUS DX/AF storage systems, then using

•

the XenServer multipath, provides improved access redundancy.

Enable the virtualization support functions (Intel VT or AMD-V) of the server before installing XenServer.

•

For details on the settings, refer to the relevant manual of the server to be used.

Install XenServer when the ETERNUS DX/AF is not connected to the server.

•

The ETERNUS Multipath Driver does not need to be installed on the XenServer Virtual Machine. The Xen-

•

Server multipath provides path redundancy.

When multiple paths are used, a multipath driver must be set. If a multipath driver is not set, the XenServ-

•

er multipath does not perform proper load balancing for the ETERNUS DX/AF.

Before setting a multipath configuration, create Storage Repositories for all the LUNs that exist in the

•

ETERNUS DX/AF.

3.2

Operating Notes

If a path error occurs in a multipath configuration using XenServer, the status of the failed multipath may

•

not be displayed. The status is displayed again when the failed path recovers.

When XenServer is managed and operated with XenCenter, multipath errors may not be detected properly

•

by XenCenter. When checking multipath status, also check the status on the XenServer host side.

3.3

ETERNUS DX/AF Setup Notes

Host Response must be set before the ETERNUS DX/AF is connected to the XenServer host.

•

Even if the Eco-mode of the ETERNUS DX/AF is enabled for a multipath configuration with XenServer, disk

motors may not stop according to the Eco-mode settings.

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix

XenServer

P3AM-4572-19ENZ0