Fujitsu ETERNUS AF250 사이트 계획 매뉴얼 - 페이지 16

{카테고리_이름} Fujitsu ETERNUS AF250에 대한 사이트 계획 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS AF250 38 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS AF250에 대해서도 마찬가지입니다: 설정 매뉴얼 (12 페이지), 구성 매뉴얼 (18 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

ETERNUS AF Installation

Installation Environment

Sufficient consideration of the installation environment should be taken to ensure proper use of the ETERNUS

AF. Using the ETERNUS AF in an environment that does not satisfy the installation environment requirements

may cause a failure to occur with the ETERNUS AF.

Installation of the ETERNUS AF in High Altitude Locations

When the ETERNUS AF is used at high altitudes (1,800m or higher above sea level), "Highland Mode" must be

enabled. When "Highland Mode" is enabled, the fans rotate at high speed to maintain the cooling effect of the

fans.

•

To set "Highland Mode", perform the subsystem parameter settings for each ETERNUS AF. The Maintenance

Operation policy is required to perform this setting.

•

The "Highland Mode" setting cannot be changed during a host access.

After the setting is changed, the ETERNUS AF needs to be turned off and on again.

•

Air Conditioning

It is important to consider the flows of cooling air (intake air and exhaust air) for the installation location of the

ETERNUS AF. The temperature in some ETERNUS AF storage systems may rise by taking in air exhausted from

other storage systems depending on how they are installed near each other. In addition, check if the ambient

temperature in the installation location always satisfies the usage environment temperature by taking into con-

sideration the room size, whether other storage systems are installed, and how many people are present in the

room.

When installing air conditioning, consider the following:

●

Ambient Temperature

An ETERNUS AF is cooled by taking in air through the front intakes and pushing out the exhaust air through the

rear of the ETERNUS AF. If the intake air temperature does not meet the ambient environment conditions, a

temperature error occurs and the power of the ETERNUS AF is shut down.

Front intake air temperature

•

Make sure that the front intake air temperature is between 10 and 40°C.

Rear exhaust air temperature

•

For example, when the intake air temperature is 40°C, the exhaust air temperature is 50°C or higher.

The necessary cooling capacity of air conditioning must be determined by taking the exhaust air cooling into

consideration.

Estimate the amount of heat in the exhaust air from the ETERNUS AF by using the heat generation amount

and exhaust air amount that are listed in

"Installation Specifications" (page

FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Site Planning Guide

7).

P3AG-1812-06ENZ0