Fujitsu ETERNUS DX Disk 구성 매뉴얼 - 페이지 29

{카테고리_이름} Fujitsu ETERNUS DX Disk에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX Disk 35 페이지. Server connection, fcoe for linux driver settings for converged network adapter cards
Fujitsu ETERNUS DX Disk에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (44 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (29 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (31 페이지), 구성 매뉴얼 (43 페이지), 구성 매뉴얼 (21 페이지), 구성 매뉴얼 (24 페이지)

페이지 인쇄

Chapter 2

Setup Procedure for QLogic Converged Network Adapter Cards

2.2

Setting Up the Converged Network Adapter Cards

2.2.5

Setting Up the Converged Network Adapter Card Driver

Change the parameters for the Converged Network Adapter card driver.

2.2.5.1

For VMware vSphere 5.5

Record the module name for the Converged Network Adapter card that is loaded into VMware ESXi.

The underlined portion indicates the loaded module name. In the following example, "qlnativefc" is the

module name.

# esxcli system module list | grep qlnativefc

qlnativefc

Module names may vary depending on the Converged Network Adapter card that is used.

Check the default value for the Converged Network Adapter card.

Specify the module name for the Converged Network Adapter card that you recorded in

check the default value.

# esxcli system module parameters list -m qlnativefc | grep ql2xmaxqdepth

ql2xmaxqdepth

Change the setting values of the parameter for the Converged Network Adapter card driver.

Driver parameter

ql2xmaxqdepth

*1: Recommended value = 512 ¸ (number of FCoE ports that are connected to a single CA port) ¸

number of LUNs

(Round the result down)

Use the value of "8" if the actual result is lower.

When the value for this setting is changed, refer to "FUJITSU Storage ETERNUS DX Configuration

Guide -Server Connection- (FCoE) for VMware

Outstanding Disk Requests for virtual machines as well.

Use the following command to change the setting values when the driver parameter name is

"ql2xmaxqdepth", the number of I/Os is "8", and the module name is "qlnativefc".

# esxcli system module parameters set -p ql2xmaxqdepth=8 -m qlnativefc

Input the number of I/Os ("8" in this example) for the driver parameter setting.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

true

int

Maximum queue depth to report for target devices.

Setting value

Arbitrary (*1)

(Up to 512 for each FCoE port of the ETERNUS DX)

ESX" and change the setting value for the Maximum

true

Step 1

ESX

P3AM-4772-11ENZ0

and