Fujitsu ETERNUS DX Disk 구성 매뉴얼 - 페이지 23

{카테고리_이름} Fujitsu ETERNUS DX Disk에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX Disk 43 페이지. Server connection, fcoe for linux driver settings for converged network adapter cards
Fujitsu ETERNUS DX Disk에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (44 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (29 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (35 페이지), 구성 매뉴얼 (31 페이지), 구성 매뉴얼 (21 페이지), 구성 매뉴얼 (24 페이지)

Chapter 9

Setting the Multipaths

Three types of multipath configurations are available for the connection between the ETERNUS AF/DX and an

HP-UX server:"PV-Links", "Native Multipaths", and VxVM's "DMP".

This chapter explains how to set up the HP-UX default "PV-Links" or "Native Multipaths". Refer to the Syman-

tec Corp. documentation for VxVM's "DMP" details.

9.1

"PV-Links" is a Logical Volume Manager (LVM) function that is available for all HP-UX versions.

LVM for HP-UX supplies PV-Links as a standard function for configuring paths in a redundant configuration

(path failover function).

PV-Links is set by including multiple paths connected to one physical volume in one volume group.

Only one of the paths will be set as the Active path, with the other paths being made Standby paths.

However, load on the system may be better balanced by spreading the server accesses over multiple Active

paths.

PV-Links are only available for LVM configurations.

When using PV-Links, note the following:

Confirm that the PV-Links paths have identical target IDs.

•

For a direct connection, confirm that the PV-Links paths have identical target IDs. Confirm that the PV-Links

paths have identical target IDs, by checking the ETERNUS AF/DX CA port settings for each PV-Link path and

comparing the target IDs.

When set correctly, the device files for all paths that connect to a given ETERNUS AF/DX LUN should all be

the same after the "t" part of the name (e.g. "/dev/dsk/c4t0d0" g "0d0").

•

Disable Native Multipaths when HP-UX11iv3 is used.

For HP-UX11iv3, Native Multipaths are enabled by default. To enable PV-Links equivalent operation, the

Native Multipaths must be disabled.

Native Multipaths are disabled by setting the "leg_mpath_enable" parameter to "false" and using Legacy

DSF for access.

Native Multipaths are always enabled when using Persistent DSF access.

Reference

Device special file type

Legacy DSF

Persistent DSF

FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for HP-UX

Example device special file

/dev/dsk/c4t0d0

/dev/rdsk/c4t0d0

/dev/disk/disk25

/dev/rdisk/disk25

P3AM-3772-22ENZ0