Fujitsu ETERNUS DX Disk 구성 매뉴얼 - 페이지 11

{카테고리_이름} Fujitsu ETERNUS DX Disk에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX Disk 24 페이지. Server connection, fcoe for linux driver settings for converged network adapter cards
Fujitsu ETERNUS DX Disk에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (44 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (29 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (35 페이지), 구성 매뉴얼 (31 페이지), 구성 매뉴얼 (43 페이지), 구성 매뉴얼 (21 페이지)

Chapter 3

Notes

Note the following issues when connecting the ETERNUS DX to a server.

3.1

Check the BIOS and firmware versions for the SAS cards being used. If these are different from the versions in

the "Server Support Matrix", download and install the appropriate BIOS or firmware version from the SAS card

vendor's web-site.

3.2

Before turning the server on, check that the ETERNUS DX storage systems are all "Ready". If the server is

turned on and they are not "Ready", the server will not be able to recognize the ETERNUS DX storage systems.

Also, when the ETERNUS DX power supply is being controlled by a UPS power supply linkage, make sure that

the ETERNUS DX is never turned off before the connected servers. If turned off, data writes from the running

server cannot be saved to the ETERNUS DX storage systems, and already saved data may also be affected.

3.3

For details involving RHEL, refer to the Red Hat web-site and any documentation available.

3.4

For details involving SLES, refer to the Novell web-site and any documentation available.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (SAS) for Linux

P3AM-3472-14ENZ0