Fujitsu Eternus DX200F 운영 매뉴얼 - 페이지 3
{카테고리_이름} Fujitsu Eternus DX200F에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX200F 48 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu Eternus DX200F에 대해서도 마찬가지입니다: 설정 매뉴얼 (10 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (16 페이지), 구성 매뉴얼 (38 페이지), 안전 주의사항 (12 페이지)
페이지 인쇄
Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX200F All Flash Array (herein-
after referred to as ETERNUS DX200F or ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes the operation management and maintenance of the ETERNUS DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.
About This Manual
Organization
This manual is composed of the following six chapters:
•
"Chapter 1 Component Name/LED Name" (page 12)
This chapter provides component names of the ETERNUS DX.
"Chapter 2 Basic Operation" (page 19)
•
This chapter explains how to turn on and off the ETERNUS DX and how to operate the buttons on the oper-
ation panel.
"Chapter 3 Storage System Monitoring" (page 25)
•
This chapter describes the status monitoring of the ETERNUS DX.
"Chapter 4 Maintaining Optional Products " (page 29)
•
This chapter explains how to install drives and host ports in the ETERNUS DX and how to register the li-
cense.
"Chapter 5 Maintenance" (page 39)
•
This chapter describes maintenance once the ETERNUS DX starts to be operated.
"Chapter 6 Troubleshooting" (page 40)
•
This chapter explains troubleshooting when errors occur on the ETERNUS DX.
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
3
Preface
First Edition
May 2014
P3AM-8472-01ENZ0