Fujitsu Eternus DX440 S2 사용자 설명서 - 페이지 20

{카테고리_이름} Fujitsu Eternus DX440 S2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX440 S2 42 페이지. Disk storage system settings
Fujitsu Eternus DX440 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 설치 설정 (20 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (15 페이지)

페이지 인쇄

Chapter 6

Setting Up the VMware ESX Server

This chapter describes settings related to the server iSCSI interface.

6.1

For VMware vSphere

Set up the VMware ESX server using the vSphere Client. The procedures described here are based on the fol-

lowing multipath configuration.

●

For the ETERNUS DX Disk storage system

For example, a total of four IP addresses are required by the following iSCSI connection setup.

Example connection configuration

VMkernel (iSCSI Software Initiator)

IP address (1)

IP address

for iSCSI port (3)

6.1.1

Turning on the Devices

To turn on the connected devices, use the following procedures:

Turn on the LAN switch power.

Check that the LAN switch's Ready (or equivalent) LED is lit.

Turn on the ETERNUS DX Disk storage system.

Check that the Ready LED is lit on the ETERNUS DX Disk storage system.

ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware

VMware ESX server

LAN card

LAN switch

ETERNUS DX Disk storage system

VMkernel (iSCSI Software Initiator)

IP address (2)

LAN card

LAN switch

IP address

for iSCSI port (4)

ESX

P3AM-3412-13ENZ0