Fujitsu Eternus DX600 S3 수동 서버 연결 구성 - 페이지 9

{카테고리_이름} Fujitsu Eternus DX600 S3에 대한 수동 서버 연결 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX600 S3 12 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu Eternus DX600 S3에 대해서도 마찬가지입니다: 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (18 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

1. Setting the To-Server Connection Type (Setting the Fcoe Port Parameters)

Chapter 2

Setting Up the ETERNUS DX

2.1

Common Settings

2.1.3

Setting the Host Responses

The host response parameters for the ETERNUS DX must be set to match the way the server processes the

responses to requests from the ETERNUS DX. Setting of the host response must be done before connecting

the ETERNUS DX to the server.

Set the parameters that are described below for each OS.

Retain the default values for all of the parameters that are not described below.

Table 2.2 Host response settings

Solaris

Windows

Linux

VMware ESX

2.1.4

Setting the CA Port Groups

Create new FCoE port groups and register the ports as members of the groups. A port group is a group of

ports that access the same LUN group (ports that are used for multipath connection to the server or for con-

necting to the cluster configuring server). Configure the host affinity setting for each FCoE port group.

2.1.5

Registering the WWNs of the Accessing Converged Network Adapter Cards

(Setting FCoE Host)

NUS DX. At the same time, set the host response registered in

accept these FCoE hosts (WWNs).

Registering the FCoE host WWNs and setting up Host Affinities as described elsewhere, allows limits to be set

on which servers are allowed to access which ETERNUS DX LUNs.

When a server-side Converged Network Adapter card is replaced, the WWN of the replacement Converged

Network Adapter card must be re-registered to the ETERNUS DX.

Conditions

When using the OS standard Multipath Driver

(MPxIO)

Other cases

–

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Host response selection

Solaris MPxIO

Default

"2.1.3 Setting the Host Responses" (page 9)

P3AM-7982-05ENZ0