Fujitsu ETERNUS DX8100 S2 사용자 설명서 - 페이지 34

{카테고리_이름} Fujitsu ETERNUS DX8100 S2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX8100 S2 42 페이지. Disk storage system settings
Fujitsu ETERNUS DX8100 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (15 페이지)

페이지 인쇄

Chapter 6

Setting Up the VMware ESX Server

6.2

For VMware Infrastructure 3

6.2.4

Setting the Software Initiator

Enable Software Initiator in VMware ESX.

Select the [Configuration] tab on VMware Infrastructure Client and click [Storage Adapters].

Select the target iSCSI Software Adapter and click [Properties].

Click [Configure] on the [General] tab.

Select the [Status-Enabled] checkbox and click the [OK] button.

Confirm that the [Enabled] checkbox is selected under "Status" on the [General] tab and click [Config-

ure] again.

Confirm that the iSCSI name is displayed as follows and click the [Cancel] button.

Select the [Dynamic Discovery] tab and click the [Add] button.

Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk storage system as the iSCSI

server IP address, confirm that the port is set to "Port 3260" (default), and click the [OK] button.

ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware

ESX

P3AM-3412-13ENZ0