Fujitsu ETERNUS DX8400 사용자 설명서 - 페이지 20
{카테고리_이름} Fujitsu ETERNUS DX8400에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX8400 42 페이지. Server connection, (iscsi) for hp-ux
Fujitsu ETERNUS DX8400에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 구성 매뉴얼 (28 페이지)
Chapter 6
Setting Up the VMware ESX Server
This chapter describes settings related to the server iSCSI interface.
6.1
For VMware vSphere
Set up the VMware ESX server using the vSphere Client. The procedures described here are based on the fol-
lowing multipath configuration.
●
For the ETERNUS DX Disk storage system
For example, a total of four IP addresses are required by the following iSCSI connection setup.
Example connection configuration
VMkernel (iSCSI Software Initiator)
IP address (1)
IP address
for iSCSI port (3)
6.1.1
Turning on the Devices
To turn on the connected devices, use the following procedures:
1
Turn on the LAN switch power.
2
Check that the LAN switch's Ready (or equivalent) LED is lit.
3
Turn on the ETERNUS DX Disk storage system.
4
Check that the Ready LED is lit on the ETERNUS DX Disk storage system.
ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware
VMware ESX server
LAN card
LAN switch
ETERNUS DX Disk storage system
Copyright 2013 FUJITSU LIMITED
VMkernel (iSCSI Software Initiator)
IP address (2)
LAN card
LAN switch
IP address
for iSCSI port (4)
20
®
ESX
P3AM-3412-13ENZ0